The 5.0kw competition series amplifier is a 5,000 watt mono block. It is capable of running up to 18 volts for up to 7,300 watts. It is a linkable amp and designed to run a 1 ohm per amp or 2 ohms when strapped. It comes with a bass knob and a clipping indicator. For power inputs it will accept dual 0 awg for power and dual 0 awg for ground.

Key Features • 1 ohm stable • Variable low pass filter • Variable subsonic filter • Variable bass boost • Wired remote control • Clipping indicator • Dual 0 awg power and ground inputs (both must be used)

We recommend for installation • 1 upgraded battery under the hood • 1 extra 800ci battery in the rear • Minimum of two 0 awg ran from the front battery to the rear battery • Both 0 awg power and ground inputs on amp must have 0 awg ran to them for a total of 4 runs into the amp • Upgraded aftermarket alternator • Dash mounted voltage meter

Specifications
	Features	Voltage	5.0kw
Output Power (RMS)	4 ohm	14.4V	900W x 1
	2 ohm		2,300W x 1
	1 ohm		5,000W x 1
	1 ohm	16V	6,000W x 1
	1 ohm	18V	7,300W x 1
Input Sensitivity			6V~0.2V
Low Pass Filter	Switchable
( @ 24 dB Slope)	Variable	Hz	35~250
Subsonic Filter	Switchable
( @ 24dB slope )	Variable	Hz	10~50
Bass Boost	Variable	dB	0-9dB
Frequency Response		Hz	15-270
Signal to Noise Ratio		dB	100
Damping factor			150<
Efficiency @ 4ohm		%	Over 90%
THD @ 4ohms			Less than 0.1%
Fuse Rating			500 Amps
Linked Fuse Rating			1000 Amps
Indicator	Power		Yes
	Protection		Yes
	Clip		Yes
Speaker & Power terminal	Mold Type		Yes
	Power	Gauge	0Ga
Heatsink Length	inch/mm		25.59"/650mm
Heatsink Width	inch/mm		9.38"/66mm
Heatsink Height	inch/mm		2.35"/59.6mm

Key Features

• 1 ohm stable

• Variable low pass filter

• Variable subsonic filter

• Variable bass boost

• Wired remote control

• Clipping indicator

• Dual 0 awg power and ground inputs (both must be used)